Rinse Cycle; Spin Cycle; Drainage; Intermediate Spin - Daewoo D-CV701PC Series Service Manual

2-2. Rinse Cycle

1) Drainage

1 If the water is 55°C or hotter, cold water is added to lower the water temperature. When the water
temperature decreases to 50°C or lower, water drainage resumes.
2 After the water drainage starts, the drain pump continues to work.
3 If the water level lowers to the reset level within 60 seconds, the waiting time of 20 seconds applies.
Otherwise, the waiting time of 40 seconds applies.

2) Intermediate Spin

1 Intermediate spin is run at the pre-determined speed for each program.
RPM
3) Water Supply
1 Only cold water is supplied to the rinse cycle.
2 Fabric softener is added to the final rinse cycle.
4) Resupply of Water
1 The water level is measured a minute after the rinse cycle starts to determine whether water needs to be
added to raise the water level to the preset level.

2-3.Spin Cycle

1) Drainage
1 It is equivalent to the drainage cycle for rinsing.
2-3.Spin Cycle
1) Termination of Door Lock
1 After the electric signal to door lock is cut off, the door is shaken horizontally until it becomes mechanically
openable.
RPM
20
RPM