Table of Contents
Advertisement
2. Program Functions
2-1. Wash Program
1) Wash Programs
1 The default washing times and water levels apply for all the programs without sensing the load.
2) Wash Times
* Washing time after the water temperature reaches the target level.
1 The washing time consists of heating cycle and post-heating main wash cycle. The time displayed for
heating cycle elapses immediately on completion of heating cycle or remains unchanged until the heating
cycle is over.
2 The heating cycle is complete when the water temperature reaches the target level.
- If the water temperature doesn't reach the target level after the heating cycle under the Baby Care, Cotton
40, Cotton 60, Intensive 40, Intensive 60, program, the time on display stops declining and an additional
heating cycle applies for 10 minutes. If the water temperature doesn't reach the target level after the
additional cycle, the heating cycle is suspended and the main wash cycle starts.
3 The water heater does not resume its operation after it is turned off when the water temperature reaches the
target level.
3) Resupply of Water
1 The water level is measured every two minutes after the initial water supply to add water if the level is
lower than the pre-determined level.
2 The motor stops running during the resupply of water.
3 Water is resuppliable up to 20 times during wash. On the occurrence of the 21st water supply, the "E4" error
is displayed and the wash cycle is suspended. -> This error doesn't usually take place because of the short
duration of wash program.
- Start the pump on the occurrence of the "E4" error.
4 If the water level is below the reset level during the resupply of water, the 'IE' error is displayed and the
heater is turned off.
18
Hide quick links:
Advertisement
Table of Contents
