Daewoo D-CV701PC Series Service Manual page 46

Defects and
Details
Errors
Power cutoff or forced
Non-
shutdown during
openable
Door operation
The washer is "ON"
without any power
cutoffs.
Others
* Exchange of Door Lock Switch
[Disassembly]
1. Remove 4 body-fixing screws
2. Remove the detergent and softener containers
3. Remove 2 screws fixing the door hinge
4. Remove 6 cover screws fixing the cover tub
5. Remove 6 screws fixing the cover tub
6. Remove 2 screws fixing the door lock switch
7. Detach the door lock switch and F-PCB
connector
[Assembly]
Re-assemble the parts in the opposite sequence to
disassembly .
Inspection of Defects
Causes
and Errors
After the "power cutoff" or "forced shutdown" during operation,
"PCB MICOM" is not able to open the door. At least 5 minutes
must pass before the door becomes openable.
Water in tub Check whether the water level is above the
safety level.
High The door is automatically locked to prevent
temperature in damage from hot laundry after the spin cycle
tub is complete.
The door is automatically locked when the
connector, terminal, or solenoid wire gets
disconnected during operation. The following
instructions must apply to inspect defects.
* Check the wire connections in Door Lock Switch
PIN
Arranage
ment
(No.1 wire unavailable)
45
Resolution
2 3 4 5
Error
Mode