1. SPECIFICATIONS ITEM DWF-1094 POWER SOURCE AVAILABLE IN ALL LOCAL AC VOLTAGE AND CYCLE 50Hz 60Hz POWER CONSUMPTION 480W 550W 49Kg (GROSS : 56Kg) MACHINE NON-PUMP 50Kg (GROSS : 57Kg) WEIGHT PUMP 630mm X 980mm X 670mm DIMENSION (WXHXD) FULL AUTOMATIC 6 COURSE...
2. STRUCTURE OF THE WASHING MACHINE The parts and features of your washer are illustrated on this page. Be come familiar with all parts and features before using your washer. NOTE • The drawing in this book may vary from, your washer model. They are designed to show the different fea- tures of all models covered by this book, Your model may not include all features.
è è § § § § How to Connect the Inlet Hose How to Connect the Inlet Hose Be careful not to mistake in supplying between the hot(maximum : 50˚C) and cold water. Be careful not to mistake in supplying between the hot(maximum : 50˚C) and cold water. In using only one water tap or in case of attached one water inlet valve, connect the inlet hose to the cold water inlet In using only one water tap or in case of attached one water inlet valve, connect the inlet hose to the cold water inlet valve.
è § § How To Clean The Filter CLEANING THE LINT FILTER Pull the Filter frame Turn the lint filter Return the filter as it was, and upward. inside out, wash to insert the filter frame into the the lint off with water. slot.
4. FEATURE AND TECHNICAL EXPLANATION Feature of the Washing Machine 1 The first air bubble washing system in the world. 2 Quiet washing through the innovational low-noise design. 3 The wash effectiveness is much more enhanced because of the air bubble washing system. 4 The laundry detergent dissolves well in water because of the air bubble washing system.
Pulsator System When the pulsator is rotated C.W or C.C.W at a high speed, it makes the cyclone water flow from the asymmetrically designed pulsator as shown below. Asymmetrically designed pulsator makes the cyclone water fow, which get rid of the washing dead zone to increase the washing effect and reduce the entanglement of laundry.
Automatic Unbalance Adjustment This system is to prevent abnormal vibration during intermittent spin and spin process. FUNCTIONAL PRINCIPLE Contact of safety switch Lid closing 1 When the lid is closed, the safety switch contact is “ON” position. 2 In case that wash loads get uneven during spin, the outer tub hits the safety switch Lid opening due to the serious vibration, and the spin...
Lint Filter Much lint may be obtained according to the kind of clothes to be washed and some of the lint may also sticks to the clothes. Filter Filter To minimize this possibility a lint filter is provided on the upper part of the tub to filter the wash water as it Bleach Bleach Inlet Inlet...
Gear Mechanism Ass’y The proper water currents is made by the rotation of pulsator at a low speed to prevent the damage to the small sized clothes. Sun gear Planetary gear Internal gear Motor Pulsator 1490 r.p.m (50Hz) Gear unit as 1 revolution Motor Pulsator...
7. TECHNICAL POINT Valve Drain Assy and Gear Mechanism We changed the shape of the Lever because of preventing water leakage and noise of G/M. Please refer to the changing date as following table OLD type NEW type Valve Drain Assy G/M with Tub O Part name Part Cord...
– check the assemble condition by moving Lever 2~3 times Pulley Motor Assy In case of replacing the Motor from OLD type to NEW type, Daewoo will supply Motor condenser, Pulley motor assy, Motor Cushion (down) together. OLD type OLD type...
Switch Safety Ass’y Replacing method from OLD type to NEW type. Please use the “Special connector’ which will be supplied by Daewoo. OLD type NEW type Appearance Structure lead wire type terminal type Part name Part Cord Specification Part Cord...
9. PRESENTATION OF THE P.C.B ASS’Y Concerning Error Message MESSAGE CAUSE SOLUTION Install drain hose properly. Improper installation of drain hose. Remove foreign matter from drain hose. The drain hose is blocked up by foreign matter. Change drain motor. Drain motor is inferior. Open the water tap.
Page 16
è § § [Dwf-1094 non-pump] WIRING DIAGRAM...
Page 17
è § § [Dwf-1094 non-pump, single valve] WIRING DIAGRAM...
Page 23
2. Parts List DWF-1094 PARTS NAME PARTS CODE EA DESCRIPTION REMARK GASKET VALVE 3612300110 PVC-S 1EA;SINGLE VALVE PANEL B 3614217610 3615405560 220V/60Hz VALVE INLET AS 3615405571 220-240V/50Hz (ONLY COLD) 3615405550 110-130V/60Hz 3615405500 220V/60Hz 3615405531 220-240V/50Hz VALVE INLET AS 3615407500 220-240V/50Hz...
Page 24
SCREW TAPPING 7122501611 T2 TRS 5x16 MFZN PUMP MODEL 3618957310 AC110-127V/60Hz DWF-1094PT/PS 3618957280 AC 220V/60Hz DWF-1094PL MOTOR SHADED POLE 3618957250 AC 220V/50Hz DWF-1094PN 3618957220 AC 240V/50Hz DWF-1094PM FILTER AS 3611901530 DWF-5590DPNF, E-TYPE PUMP MODEL BALANCER AS 3616104000 DWF-1094 PARTS DIAGRAM...
Page 25
3611903300 NYLON, 100x150 FILTER AS FRAME FILTER 3611903000 ;3611903100 HOLDER 3613008900 SPECIAL SCREW 3616003700 SUS 5.5x16 GUIDE FILTER AS 3612504100 DWF-1094 3618806900 SUS430D TUB U 3618807001 PP, -M/B SPECIAL NUT 4507D83080 SUS 304 FLANGE TUB 3617201200 10Kg, 3-FOOT SPECIAL SCREW 3616007000 SCM24H, 6.5x24...
Page 26
è § § DWF-1094 Circuit Diagram CIRCUIT DIAGRAM...
Need help?
Do you have a question about the DWF-1094 and is the answer not in the manual?
Questions and answers