Surround Panel Installation - Lopi Freedom Owner's Manual

O
PTIONAL
P 30
AGE
S P
URROUND ANEL
Surround panel size is determined by the type of installation and the size of the fireplace opening.
Direct and positive connections do not require insulation or panels that overlap the fireplace opening
(panels that overlap the fireplace opening are usually more attractive). Face seal connections require
surround panels that overlap the fireplace opening on the top and sides at least 2" (2 1/2" for rough
surfaces). This overlap is needed for the insulation that forms the airtight seal between the surround
panels and the fireplace. Any questions on selection of the surround panels should be directed towards
your dealer. The table below details the size of the surround panels when installed. The surround panels
should be installed prior to installing the insert. Place the insert 12" from the fireplace opening while
installing the surround panels.
SURROUND PANEL SIZE
8"
10"
12"
1. Follow the directions in the illustration below to install the side panels.
1.
Place the side
surround panel so
the inside flange
fits inside the side
convection
chamber. Note
how the cook top
fits into the notch.
Insert the two screws (included in insert owner's pack) through the
panel & side convection panel and into the two nuts (also included
in owner's pack). Turn a couple of times but do not tighten.
2. Attach the mounting angle to the top of the insert (see the illustration on the following page).
Install the top panel. Adjust the top panel so its edges are flush with the side edges of the side
panels.
E
QUIPMENT
I
NSTALLATION
(S
SIZE ON APPLIANCE (Including Trim)
45 3/8" width by 29 1/2" height
49 3/8" width by 31 1/2" height
53 3/8" width by 33 1/2" height
Side
Surround
Panel
Inside
Flange
2.
(C )
ONTINUED
EE TABLE BELOW FOR PART NUMBER
)
PART #
99300104
99300105
99300111
Cook Top
Top of Insert
Side
Convection
Panel
3.
Repeat for the opposite side.
Back
of
Insert