Table of Contents
Advertisement
1 4
Surround Panel & Circuit Board Installation
N O T E : Attach the vent prior to installing the surround panels (& circuit board).
a
b
Bend these block-
off plates as
shown (both
sides). When in
position, they
Back of
block the view
Side Panel
through the slots.
in the surround
panels.
Place the right side surround panel near
d
the insert and attach the wiring harness
to the circuit board.
Back Side of
Circuit Board
Pinch these tabs to
remove the wiring
harness.
Wiring Harness
(disconnected
in step "a")
© Travis Industries
Installation
NOTE: When in place, the
panels maintain a 3/8" gap
around the fireplace.
Phillips
Screwdriver
Remove the circuit board from the rear
hopper support. Disconnect the wiring
harness from the circuit board (see step
"d" below for a detailed view).
c
Attach the circuit board
with the four screws
shipped with the insert.
Phillips
Screwdriver
If using a thermostat,
attach the thermostat
wires at this time.
Attach the surround panels to the insert by sliding the slots
e
on each panel over the tabs on the side of the insert.
Run the power cord to the side along
the front of the fireplace behind the side
panel (do not route it under the insert).
f
Right Side
Surround
Panel
Double-Back Tape
4 0 8 0 7 2 3
Tab
Install the top panel so the joggle clips slide over
the tabs on top of the side panels and insert.
Top Trim
Top Panel
1 0 0 - 0 1 1 4 5
Slot
Tighten the set screws
from the back side with a
small standard screwdriver
"L" Bracket
Right Side Trim
Optional Trim Installation:
Insert one leg of each "L" bracket
into the top and side trim piece.
Align the trim to form a precise
corner, then tighten the two set
screws with a small standard
screwdriver. Slide the trim over
the panels. Attach the double-
back tape between the trim and
panels at the bottom corners.
This keeps the trim tight against
the panel and prevents rattles.
Advertisement
Table of Contents
