Table of Contents
Advertisement
F
K
LUSH
IT
(P
# 99900151)
ART
This kit allows the Freedom insert to be installed with more of the unit inside the fireplace (flush) rather
than extended onto the hearth. The flush kit must be installed prior to installing the surround panels or
placing the insert. Place the insert 24" onto the hearth before following the instructions below.
1. Remove the bypass rod from the insert (see illustration below).
2. Remove the eye bolt from the bypass rod. Discard the original bypass rod.
3. Pre-thread the 8 mounting holes on air chamber top & side extensions (see illustration below).
4. Place the air chamber side extension in place and attach with the included screws.
5. Place the air chamber top in place and attach with the included screws.
6. Included with the flush kit is an extended bypass rod. Thread the eye bolt onto the extended
bypass rod. Then attach the extended bypass rod to the yoke.
7. The surround panels attach to the air chamber side extensions in the same manner they attach to
the insert.
1.
Grasp the bypass rod with a pair of pliers or
vise grips and unscrew it from the yoke.
Bypass Rod
1.
Pre-thread the
8 mounting
holes on the air
chamber
extensions
using one of
the included
screws and a
5/16" nutdriver.
Use these holes
to mount the
surround panels.
O
PTIONAL
Yoke
The rod is threaded to
allow disconnection
2.
Remove the bypass rod from the eye bolt.
Use pliers or vise grips to hold the rod, then
twist the eye bolt off using a screwdriver
Eye Bolt
inserted through the eye bolt for leverage.
2.
Place the air chamber side in place
and attach with the included screws.
E
QUIPMENT
N O T E:
The bypass rod may be
routed above or through
the top convection
chamber. The instructions
remain the same for both.
Bypass
Damper
Place the air chamber
3.
top in place and
attach with the
included screws.
Top of Insert
Back
of
Side of
Insert
Insert
P
29
AGE
Hide quick links:
Advertisement
Table of Contents
