Dispensing Milk And Milk Foam - WMF 800 User Manual

Dispensing milk and milk foam

At the touch of a button, the WMF 800 also dispenses warm milk and milk foam.
press briefly
1 cup milk
All-in-One spout in the top position
If a beverage is selected and the All-in-One spout is not in the appropriate position, then a reminder is
shown on the display. See WMF All-in-One spout page 21.
Milk or milk foam can drip out a bit after dispensing. It is best to leave the cup under the
All-in-One spout briefly after dispensing, or to place a small catch basin under the spout.
Milk can also drip out if the tetrapak is full and the All-in-One spout is in a lower position.
Slide the spout upward a little after dispensing a beverage.
Cup of warm milk
The All-in-One spout must be in the top position.
>
Place an appropriate cup under the All-in-One spout
>
Press the milk button 1x briefly
Another press of the milk button ends dispensing prematurely.
After dispensing milk, the All-in-One spout should be slid downward slightly. The display prompts for
this.
Milk foam
The All-in-One spout must not be in the top position.
>
Place an appropriate cup under the All-in-One spout
>
Press and hold the milk button
Milk foam is dispensed as long as the button is pressed.
press and hold
Milk foam on request
All-in-One spout not all the way to the top
Operation
Set cup size,
see
Settings chapter
page 26
19