WMF 800 User Manual page 13

Water hardness
>
Set the result of the carbonate hardness test with the
>
Confirm the value with the P button
After confirmation, the program jumps to the next point of the settings.
Water filter
>
Enter here with the and
–
(recommended for water hardness 5 °dKH and higher)
>
Press the P button to confirm the setting
If "water filter" is set, then the filter should be rinsed now.
>
Set a container with approx. 3 litres capacity under the hot water spout
When rinsing the filter, you will hear unusual noises. This is normal. The noises will stop during the filter
rinse.
>
Fill the water tank with cold tap water
>
Place the lid on the water tank
The lid must be on the tank when it is put in place.
>
Slowly slide the water tank back into the machine
The machine now heats up.
After the machine has heated up, there is a coffee system rinse. This warms up all the pipes.
After each brewing cycle, in the heating up phase and during the care programs, so-called release
water runs into the drip tray.
>
Place a container for the rinse water (approx. 120 ml) under the All-in-One spout
The coffee system rinse lasts approx. 40 seconds.
water hardn.: 13-16
OK: P change: -/+
and
–
water filter: no
OK: P change: -/+
buttons whether you are using a tank filter
+
place 3L container
under h. w. spout
heating up ...
buttons
+
Start-up program
Carbonate hardness test
See included accessories
Rinse filter:
Follow the display messages
Insert water filter
see Start up page 8
Change water filter
see "Care" page 40
13