Calibrating The Appropriate Settings Automatically - Sony BDV-T10 Operating Instructions Manual

66
US
Calibrating the
Appropriate Settings
Automatically
[Auto Calibration]
D. C. A. C. (Digital Cinema Auto Calibration)
can set the appropriate surround sound
automatically.
-
• The system outputs a loud test sound when [Auto
Calibration] starts. You cannot tum the volume
down. Give consideration to children and neighbors.
1
Press HOM E.
The home menu appears on the TV screen.
2
Press
+-1-+
to select;:; [Setup].
3
Press 't/'" to select [Audio Settings],
then press
CD.
4
Press 't/'" to select [Auto Calibration],
then press
CD.
The confirmation display for [Auto
Calibration] appears.
5
Connect the calibration mic to the
A.CAL MIC jack on the rear panel.
Set up the calibration mic at ear level using
a tripod, etc. (not supplied). The front of
each speaker should face the calibration
mic, and there should be no obstruction
between the speakers and the calibration
mic.
6
Press 't/'" to select [Start].
To cancel, select [Cancel].
7
Press
CD.
[Auto Calibration] starts.
The system adjusts the speaker settings
automatically.
Be quiet during the measurement.
-
• Before [Auto Calibration], make sure that the
surround amplifier turns on and you install the
surround amplifier in the appropriate location. If
you install the surround amplifier in an improper
location, such as another room, proper
measurement will not be obtained.
• When you use the Wireless Surround Speaker
Kit (WAHT-SBPI, optional) for the surround
back speakers (page 17), install the speakers in
appropriate location and turn the surround
amplifier on.
• Loud test sound is output when [Auto
Calibration] starts. You cannot turn the volume
down. Give consideration to children and
neighbors.