Sony BDV-T10 Operating Instructions Manual page 30

-
• When you do not connect the unit and TV with
an HOMI cable. you cannot select [HOMI].
• When connecting the HOMI OUT jack and
other video output jacks at the same time, select
[Component Video].
• For details about video output resolution, see
"Video Output Resolution" (page 99).
8
Press
CD
or".
The Setup Display for video output
resolution selection appears. For details. see
[Output Video Fonnat] (page 77).
When you select [HDMI] in Step 7
~
Easy Setup· HOMI Resollrtion
~:,\
Select the resolution to output to the TV. "Auto· is the standard selection.
rL:
The video switches for 30 seconds when this setting is changed.
Check that there are no problems with the video.
Nothing Is displayed on tile screen if the resolution is incorrect.
Auto
4801
480p
720p
10801
1080p
Select from [Auto]. [480i]. [480p]. [nOp].
[1080i]. or [1080p].
When connecting the HDMI OUT jack and
other video output jacks at the same time.
video signals may only output from the
HDMI OUT jack when [Auto] or [1080p] is
selected.
When you select [Component Video] in
Step 7
~ Easy Setup·
Component ResolullOrl
Select the resolution to output to the TV.
The video switches for 30 seconds when this setting is changed.
Check that there are no problems with the video.
Nothing is displayed on the screen if the resolution is incorrect.
~
00 •
480p
720p
10801
Select from [480i]. [480p]. [nOp], or
[1080i].
When you change the video
output resolution
A picture is displayed in the selected
resolution for about 30 seconds, then the
display asks for confinnation.
Follow the on-screen instructions and go to
the next step.
30
US
-
• If the picture is distorted or no picture appears.
wait for about 30 seconds without pressing any
buttons. [Is this resolution OK?] appears. Select
[Cancel]. The display returns to the resolution
setting screen.
• If the selected video output resolution is
incorrect. no picture appears on the screen. In
this case, press and hold
~
and
~
on the unit
for more than 5 seconds to reset the video output
resolution to the lowest resolution. To change
the video output resolution, set [Output Video
Format] in [Video Settings] (page 77).
9
Press 0) or".
The Setup Display for selecting the aspect
ratio of the TV to be connected appears.
~
Easy Setup· TV Type
Select the screen aspect ratio to mateA your TV.
16:9
4:3
ELED
16:9 4:3
1 0
Press
'to/oJ,
to select the setting that
matches your TV type.
• [16:9]: If you have a wide-screen TV or a
4:3 standard TV with a wide-screen mode.
(page 76)
• [4:3]: If you have a 4:3 standard TV.
(page 76)
11
Press
0)
or".
When you connect the unit and TV with
an HDM. cable
The Setup Display for the [Control for
HDMI] function appears. Go to Step 12.
When you do not connect the unit and
TV with an HDM. cable
The Setup Display for [BD Internet
Connection] appears. Go to Step 14.