JVC KW-NT1 Instructions Manual page 90

The coordinates you have entered are not available. Press
[OK] and input the coordinates again.
Valid information is not found in the database. Search for
another place. Press
[~
and search again with
different conditions (such as different category or place).
Check the connection ofthe GPS antenna.
Remedies/Causes
This is not amalfunction. The System may also search
areas around the selected city/state.
Reversing signal lead is not connected. Connect them
correctly (1&Installation/Connection Manual-separate
volume).
The destination/via point is too far from the current
position. Select another destination/via point where is
nearer to the current position.
Change the <Output> setting. (1& page 43)
Check the connection of the GPS antenna.
Guidance volume level is set to the minimum level. Adjust
. it to the optimum level. (1& page 40)
. Failed to calculate the route. The destination/via point is
,j
too far from any road. Select another destination/via point
where is close to aroad.
• Acquiring GPS signals. Wait until signal reception is
completed.
J •
GPS signals cannot be received. Move to the place where
,.>'<·····+"wu
the System receives the GPS signals.
IISel~eted coor9inate~\are 'ou.~.of
map'awa.,
Please inputagain."";, '.- " .
Symptoms,
Navigation guidance is someti,mes inc(Jlrrect.
.Check
GPSAhtenna~':z"
APOI found using <POI Name,> in the
<Destination Menu> is notwithin the
selected city/state.
"Spec,ifled destillatiol} is not
found;'~
The voiCe guidance does notcome out from the
speaker on the driver's side.
"Route calculation IS aborted because'
destination is too far."
II
Acquiring GPS Signal"
Navigation voice cannot be heard from the
speakers.
The current position displayed on the map
.remains.wron9
f9r{llgr,~,th~~,
3Q minMt,e,s.:,
Troubleshooting
90