Av Menu Items - JVC KW-NT1 Instructions Manual

AV
menu items
I
Selectable settings
Fader: Adjust the front and rear speaker output balance.
• F6 to R6; Initial
~
- When using atwo-speaker system, set the fader to the center (0).
Balance: Adjust the left and right speaker output balance.
• L6 to R6; Initial
~
Press [A/"-/
~/~
] or drag the cursor to adjust.
• To set the fader and balance to the center (0), press [Center].
Flat/Hard RocklR&B/Pop/JazzlDance/Country/Reggae/Classic/
User1/User2/User3
(1tW
page 67)
Adjust the subwoofer output level, Cross Over, and High Pass Filter.
Press [Enter] to adjust each setting.
• Level: Adjust the subwoofer output level.
-6 to +8; Initial
~
• Cross Over: Adjust the crossover frequency between the front/rear
speakers and the subwoofer.
80Hz, 120Hz, 150Hz
• High Pass Filter:
On: Select when the subwoofer is connected.
Through: Select when the subwoofer is not connected.
When this function is activated, the System automatically increases the
volume level (both for guidance and audio) as the car speeds up.
Off,
Min, Mid, Max
Muting1, Muting2: Select either one which mutes the sounds while
using the cellular phone.
Off: Cancels.
You can change the maximum volume level of this unit.
High: VOL 0to 20 (for guidance)NOL 00 to 50 (for audio)
Low: VOL 0to 15 (for guidance)NOL 00 to 30 (for audio)
(Selectthis ifthe peak power of the speakers is less than 50 W.)
Off:
Deactivates the bUilt-in amplifier (VOL 0to 20 for guidanceNOL 00
to 50 for audio.)
*1
The TEL MUTING lead connection is required.
(1tW
Installation/Connection Manual)
68