Monitor Output L/R Connectors - Sony SRW-5800 Operation Manual

1 ANALOG I/O (input/output) section
a MONITOR OUTPUT L/R connectors
(XLR-3-31, male)
These output the audio signals for monitoring L and R
channels. To select the signals to output, use the
MONITOR L and MONITOR R buttons on the lower
control panel.
For details, see "5-1-2 Selecting Audio Signals" on
page 118.
b REF. INPUT 1 connectors (BNC) and 75Ω
termination switch
Input a reference video signal of the selected field
frequency. Select HD or SD with the VTR SETUP menu
item 006 "EXTERNAL REFERENCE select". When HD
is selected, input a tri-level SYNC signal. When SD is
selected, input a video signal with chroma burst (VBS) or
a monochrome video signal (VS).
A loop-through connection is possible. Set the 75Ω
termination switch to OFF if you are using a loop-through
connection and set it to ON if you are not using a loop-
through connection.

1 MONITOR OUTPUT L/R connectors

2 REF. INPUT 1 connectors and 75Ω termination switch
3 REF. INPUT 2 connectors and 75Ω termination switch
4 HD REF. OUT connectors
5 SD OUT SYNC connector
6 SD OUT COMPOSITE (MONITOR) connector
7 TIME CODE OUT connector
8 CUE OUT connector
9 TIME CODE IN connector
c REF. INPUT 2 connectors (BNC) and 75Ω
termination switch
Input a reference video signal of the field frequency
selected for the format converter output. Select HD or SD
with the VTR SETUP menu item A08 "FC REFERENCE
select". When HD is selected, input an HD tri-level SYNC
signal for external synchronization. When SD is selected,
input a video signal with chroma burst (VBS) or a
monochrome video signal (VS). A loop-through
connection is possible. Set the 75Ω termination switch to
OFF if you are using a loop-through connection and set it
to ON if you are not using a loop-through connection.
d HD REF. OUT connectors (BNC)
Output an HD tri-level sync signal during tape playback.
Notes
• When the system is operated in 4:2:2/720P mode, no
signal is output from these connectors.
• When the system is operated in 4:2:2/1080/50P, 4:2:2/
1080/59.94P, or 4:2:2/1080/60P mode, the reference
signal that is identical to interlace signal is output from
these connectors.
25
2-2 Connector Panel