Lower Control Panel; Phones Jack; Monitor L Buttons; Monitor R Buttons - Sony SRW-5800 Operation Manual

Note
When the VTR is being controlled by the external
equipment connected to the REMOTE 1-IN(9P) or
REMOTE 2 PARALLEL I/O(50P) connector, all tape
transport buttons and edit operation buttons are disabled,
except the STOP and EJECT buttons. You may also
specify the disabling or enabling of all buttons by setting
the VTR SETUP menu item 008 "LOCAL FUNCTION
ENABLE".

2-1-2 Lower Control Panel

1 Menu control section
9 DISPLAY button
0 FULL/FINE button
qa PB LEVEL button
qs REC LEVEL button
a MONITOR L buttons
Select the audio signal output from the MONITOR
OUTPUT L connector. This assigns the desired channel to
the MONITOR OUTPUT L connector. If you assign more
than one channel to the same monitor output connector, a
mixed audio signal is output.
You can also make this setting using the VTR SETUP
menu item 807 "AUDIO MONITOR-L select".
In the audio playback level adjustment mode, this is used
to select the channel to be adjusted.

1 MONITOR L buttons

CH1 CH2 CH3
OVER OVER OVER
dB dB dB dB
0 0 0 0
-10 -10 -10 -10
-20 -20 -20 -20
-30 -30 -30 -30
-40 -40 -40 -40
L R L R L R
CH1 CH2 CH3
EDIT PRESET
F1
F2
F3
F4
DIAG
ALT F5 F6 F7
7 ALT button
8 DIAG button
h PHONES level control
Adjusts the output level to the PHONES jack.
For details, see "5-1-2 Selecting Audio Signals" on
page 118.
i PHONES jack
Connect stereo headphones for audio monitoring during
recording, playback, and editing. Adjust the headphone
output level with the PHONES level control.
CH4 CH5 CH6 CH7 CH8 CH9 CH10 CH11 CH12
R
OVER OVER OVER OVER OVER OVER OVER OVER OVER
dB dB dB dB dB dB dB dB
0 0 0 0 0 0 0 0
-10 -10 -10 -10 -10 -10 -10 -10
-20 -20 -20 -20 -20 -20 -20 -20
-30 -30 -30 -30 -30 -30 -30 -30
-40 -40 -40 -40 -40 -40 -40 -40
L R L R L R L R L R L R L R L R L R
CH4 CH5 CH6 CH7 CH8 CH9 CH10 CH11 CH12
VIDEO TC
F8 F9 F10
5 Color display
6 Function buttons
b MONITOR R buttons
Select the audio signal output from the MONITOR
OUTPUT R connector. This assigns the desired channel to
the MONITOR OUTPUT R connector. If you assign more
than one channel to the same monitor output connector, a
mixed audio signal is output.
You can also make this setting using the VTR SETUP
menu item 808 "AUDIO MONITOR-R select".
In the audio playback level adjustment mode, this is used
to select the channel to be adjusted.

2 MONITOR R buttons

3 MULTI CONTROL knob
MULTI
L
CONTROL
MONITOR
HOME
TC
VIDEO
AUDIO
CUE
PF1
PF2
SET UP
4 Menu selection buttons
2-1 Control Panel
17