Table of Contents
Advertisement
PROGRAMMING
You may store up to 16 keypad digits including the PAUSE or TAP
fixed feature, if needed, at programmable button locations for
autodialing.
All 12 programmable buttons may be used for number storage, or
you may use 11 programmable buttons for number storage and store
a SPEED button function in the lower right-hand programmable
button location (Figures 2 and 3). The SPEED button lets you store
additional numbers using keypad locations. Memory contents are
protected by a long-life lithium battery, which provides memory-
retaining power for approximately seven years.
Programming controls are located beneath the telephone faceplate.
Before you remove the faceplate, remove the clear plastic cover
of the message waiting
indicator
by pulling it straight up. Then:
1. Remove the two-piece faceplate to gain access to the
programming controls.
2. Refer to Figures 2 and 3 for the
actual
location'of the
controls for
PAUSE, STORE,
and
TAP.
3. Look in the openings - you will see a small, silver, circular
actuator in each opening. This is the programming control.
4. To actuate each control, carefully press down on it with a
blunt wooden or plastic probe approximately l/g-in,
diameter.
Storing Numbers at Programmable Button Locations
NOTE: The telephone must be connected to the line before you canpro-
gram it.
1. Lift handset.
2.
Press
STORE.
3. Press desired programmable button.
4. Dial number to be stored (16 digits maximum). If needed,
press
TAP
for a hookswitch flash signal and
PAUSE
for a
pause between numbers. A valid entry causes an acknow-
ledge tone or a click to sound from the speaker if you have
a speakerphone and from the handset receiver if you don't.
An invalid entry causes an error tone or a buzz to sound.
Continued on next page...
Advertisement
Table of Contents
