Table of Contents
Advertisement
PROGRAMMING
You may store up to 16 keypad digits including the PAUSE or TAP
fixed feature, if needed, at programmable button locations for
autodialing.
All 12 programmable buttons may be used for number storage, or
you may use 11 programmable buttons for number storage and store
a SPEED button function in the lower right-hand programmable
button location (Figure 2). The SPEED button lets you store addi-
tional numbers using keypad locations. Memory contents are
protected by a long-life lithium battery, which provides memory-
retaining power for approximately seven years.
Programming controls are located beneath the telephone faceplate.
Before you remove the faceplate, remove the clear plastic cover
of the message waiting indicator by pulling it straight up. Then:
1.
2.
3.
4.
Remove the two-piece faceplate to gain access to the
programming controls.
Refer to Figure 2 for the actual location of the controls for
PAUSE, STORE, and TAP.
Look in the openings - you will see a small, silver, circular
actuator in each opening. This is the programming control.
To actuate each control, carefully press down on it with a
blunt wooden or plastic probe approximately l/8-in.
diameter.
Storing Numbers at Programmable Button Locations
NOTE:
The telephone
must
be connected
to the line before
you canpro-
gram
it.
1.
2.
3.
4.
Lift handset.
Press STORE.
Press desired programmable button.
Dial number to be stored (16 digits maximum). If needed,
press TAP for a hookswitch flash signal and PAUSE for a
pause between numbers. A valid entry causes an acknow-
ledge tone or a click to sound from the handset receiver.
An invalid entry causes an error tone or a buzz to sound.
Cotiinued
on next page...
7
Advertisement
Table of Contents
