Enabling The Speed Button; Disabling The Speed Button; Storing Numbers At Keypad Locations (To Be Accessed By Speed Button) - Comdial HoTelephone 3910S User Manual

Programming (continued)
NOTE: A two-secondpause is stored each time the PAUSE control is
pressed. A fued 6.50 msec hookwitch flash signal is stored each
time the TAP control is pressed.
PAUSE and TAP each equal
one digit in the 16-digit total.
5.
Press
STORE
to end programming sequence. After the
16th digit is stored, the programming sequence will end
automatically. Success tone will sound to indicate success-
ful programming sequence.
6. Repeat steps 2-5 for each programmable button.
Enabling the SPEED Button
1. Press
STORE, *,
and lower right-hand programmable
button (Figures 2 and 3).
2.
Press
STORE
again.
3. Label the programmable button "Speed."
Disabling the SPEED Button
l
Press STORE,
#, SPEED, STORE.
Storing Numbers At Keypad Locations (to be accessed
by SPEED button)
1. Lift handset.
2. Press STORE.
3. Dial speed location from keypad (O-9).
4. Dial number to be stored (16 digits maximum). If needed,
press
TAP
for a hookswitch flash signal and
PAUSE
for a
pause between numbers. A valid entry causes an acknow-
ledge tone or a click to sound from the speaker if you have
a speakerphone and from the handset receiver if you don't.
An invalid entry causes an error tone or a buzz to sound.
5.
Press
STORE
to end programming sequence. After the
16th digit is stored, the programming sequence will end
automatically. Success tone will sound to indicate success-
ful programming sequence.
6. Repeat steps 2-5 for each speed dial location.
Continued on next page...
12