Rear Panel - Planet FSD-804PS User Manual

The following is the summary table of Reset button functions:
Reset Button Pressed and Released
About 1 second
Until the SYS LED lit off
2.1.1 LED indicators
■ System
LED Color
PWR Green
■ Per 10/100Mbps port
LED Color
PoE in-use Green
LNK/ACT Green
1.
2.

2.2 Rear Panel

The rear panel of the FSD-804PS indicates an AC inlet power socket, which accepts input power from 100 to 240VAC,
50-60Hz. And have a fan hole on the rear panel.
1.
should active all the time, please consider using UPS (Uninterrupted Power Supply) for your device.
It will prevent you from network data loss or network downtime.
Power Notice:
2.
from being damaged by unregulated surge or current to the FSD-804PS or the power adapter.
Lights to indicate that the PoE Switch has power.
Lights to indicate the port is providing 48VDC in-line power. (1-4 ports)
Lit: indicate the link through that port is successfully established.
Blinks to indicate that the Switch is actively sending or receiving data over that port.
Press the RESET button once. The Switch will reboot automatically.
Press the RESET button for 5 seconds. The Switch will back to the factory default mode; the
entire configuration will be erased.
Figure 2-3 FSD-804PS Switch rear panel
The device is a power-required device, it means, it will not work till it is powered. If your networks
In some area, installing a surge suppression device may also help to protect your FSD-804PS
Function
Reboot the PoE Injector Hub
Reset the PoE Switch to Factory Default configuration. The
PoE Switch will reboot and load the default IP settings as
below:
Default Password: admin
。
Default IP address: 192.168.0.100
。
Subnet mask: 255.255.255.0
。
Default Gateway: 192.168.0.254
。
Function
Function
User's Manual of FSD-804PS
- 10 -