Planet FSD-804PS User Manual page 40

The page includes the following fields:
Object
VLAN Type
Management VLAN
• VLAN Group
• VID
• Member Port
1.
2.
3.
Description
There're two VLAN mode support – 802.1Q VLAN and Port-Bas VLAN
• 802.1Q – Packets income will be tagged with VID as the PVID setting. All ports
on the switch belong to default VLAN (VID 1).
• Port-Base - Packets can only be broadcast among other members of the same
VLAN group. Note all unselected ports are treated as belonging to the default
system VLAN.
• Disable - Forbidden ports are not included in the VLAN
Specifies the management VLAN ID of the Switch. It may be configured to any
value in the range of 1 - 16. The management VLAN is used for management of
the Switch.
The VLAN entry index. Select the column to specify the VLAN group for VLAN
member ports configure.
The Switch supports up to 16 active VLAN groups.
Specify the VLAN Identifier for the 802.1Q VLAN.
The available range of the VID is (1 to 4094).
( 802.1Q mode only)
Select the physical interface for which you want to add or remove from the specify
VLAN group. Checked the Member box to select the members for the VLAN
group. Number 1-8 is the Physical interface ID of the PoE Switch.
ADD: To add selected ports to the specify VLAN group.
Remove: Remove the selected ports from the specify VLAN Group.
After setup completed, please press "Apply" to take affect.
The VID value of each VLAN group must follow the rule -> there is an interval value 16 of
available VID value. For example, VLAN 2 VID must be 2, 18, 34, ....; VLAN 3 VID must be 3,
19, 35...
There is no way to delete a VLAN group on the PoE Switch. Just cancel all the check box from
Port-1 to Port-8 to make the VLAN group be not active.
Once the member port be removed from VLAN Group, the Ports with the PVID set to this VLAN
Group have to re-configure the PVID.
User's Manual of FSD-804PS
- 40 -