Windows Notes; Installing On Usb Host Powered Devices; Downloading The Windows Usb Driver; Installing On Windows 8, 7 Or Vista - Multitech MTC-C2 User Manual

INSTALLING DEVICE DRIVERS
To load the module use modprobe or insmod.

Windows Notes

Installing on USB Host Powered Devices

When you connect a USB host powered device to a computer through a USB cable, the Windows Add New
Hardware Wizard may display Cannot Install this Hardware. If this occurs, click Finish. Windows detects additional
devices and prompts you to install them.

Downloading the Windows USB Driver

If you haven't downloaded the driver:
1. Go to the Multi-Tech Support page, www.multitech.com/support.go and select your product from the
Product Families drop down list.
2. Click Drivers.
3. Extract the files to your computer.

Installing on Windows 8, 7 or Vista

This process installs multiple drivers and ports.
Note: If you previously installed USB drivers for this device, uninstall them before installing or re-installing this
driver. Uninstall all existing drivers for this device. Refer to Uninstall Windows Drivers for details.
Before you connect the device (disconnect the device if you connected it):
CAUTION: If you connected the device before installing the drivers, Windows may install drivers automatically.
Your device may not operate correctly with these drivers. Uninstall the drivers before proceeding. See Remove
Microsoft Installed Drivers for details.
1. Click Yes or Allow to allow the installer to make changes to your computer.
2. Click Next and follow the instructions in the installation wizard.
3. Click the Install option when prompted, for example, Install this driver software anyway.
4. Click Finish.
5. Connect USB cable from the device to a USB port on your computer. Windows indicates when the device
is ready to use.
16
®
MultiConnect Cell User Guide