U-Disk Master; Logout; Troubleshooting - Zte MF29A User Manual

Note:
For the detailed operations about the client, please refer to the cli-
ent's instruction.

U-Disk Master

1. Start up your device.
2. Launch the client device connected to your device.
3. Connect the storage devices (i.e.USB disk) to the USB port of
the device.
4. Select Start > Run of the computer.
5. Input \\192.168.0.1\, in the open field and press OK.
6. Input User Name and Password. The default User Name is
admin, Password is admin. Then you can view storage devices.

Logout

Select Logout, a pop-up window will appear as the following figure
shown:
Click OK to logout the web page.
42

Troubleshooting

Voice Related Problems
Symptoms
Please wait for 1~2 minutes after the
router is turned on.
No Dial Tone. If 3G LED light is blinking, you have
no good RF reception. Change the
location of the router.
Make sure your (U)SIM card is in-
There is a prompt/ phone serted correctly and the PIN number
alert/ announcement as has been entered. If the PIN number
soon as I lift the phone off has been entered incorrectly then you
the hook. will need to enter the PUK code when
prompted.
Remove any electrical appliance
The line is noisy/ distorted which is too close to the phone or
when I lift the phone off the router.
hook. The cable or phone set might be
faulty.
Put the phone on hook and try again.
I hear a rapid engaged tone
If you are connected to the internet
as soon as I lift the phone
using the 2G (GSM) network, please
off the hook.
disconnect this first.
When you have finished dialing you
After dialing the last digit I
can press the # key or wait 4-8 sec-
hear nothing /silence.
onds to connect the call.
Possible Problems/ Solutions
43