Zte MF29A User Manual page 13

• Network Name(SSID): Service Set Identifier (SSID). Enter a
string less than 32 characters as the name for your wireless local
area network (WLAN).
• Broadcast Network Name(SSID): Disable or Enable (Default)
this function. If Enable is selected, the router broadcasts the
SSID, and other devices can detect and connect to it. If Disable
is selected, the other devices cannot detect the router. You can
only connect to the router by manual setting.
• AP Isolation: When Enabled is selected, each of your wireless
clients will not be able to communicate with each other. When
Disable is selected, each of your wireless clients will be able to
communicate with each other.
• BSSID: MAC address of the Wi-Fi.
• Frequency(Channel): Choose the appropriate channel to
optimize the performance and coverage of your wireless
network.
• WDS Mode: WDS mode allows the router to communicate with
other APs, WDS connection is two-way communication, APs
should know each other's wireless MAC address. And make sure
that all APs share the same SSID and channel.
WDS configuration is shown below:
Step
1.Set the SSID and
Manually set the SSID and the same chan-
the same channel for
nel is strongly recommended.
APs
Description
24
Step
• If you select Disable, WDS is disabled.
• I f y o u s e l e c t L a z y M o d e , W D S i s
enabled, and set wireless MAC address
only on the peer APs.
• If you select Bridge Mode, WDS is
2.Select WDS mode: enabled, and set the peer APs wireless
Disable, Lazy Mode, MAC address on router. When you set
Bridge Mode or Re- Bridge Mode, your PC can not search
peater Mode SSID of AP after connected.
• If you select Repeater Mode, WDS is
enabled, and set the peer APs wireless
MAC address on router. When you set
Repeater Mode, your PC can search
SSID of AP after connected.
CCK: 802.11b
3.Select Phy mode:
OFDM: 802.11g
CCK,OFDM, HTMIX
HTMIX: 802.11b/g/n Mixed Mode
or GREENFIELD
GREENFIELD: 802.11b/g Mixed Mode
If you select NONE, all the data transmitted
without encryption, and other station can ac-
4.Select Encrypt
cess router.
Type:
If you select the Encrypt Type, you should
TKIP, AES
set all APs the same Encrypt type and pass-
word to make the data transfer.
5.Set peer AP's wire-
Only Repeater Mode and Bridge Mode
less MAC address on
need this.
router
Description
25