Calibration Guidelines And Errors - ActiGraph ACTITRAINER User Manual

To reset calibration data
1) Navigate the menu on the ActiTrainer to the "Calibrate" menu
2) Select the "Reset" option. (Note: This option will only be available if a calibration run or walk has occurred)
3) Choose "Yes" when prompted "Are You Sure"
The most recent calibration run and/or walk data is now cleared out.
This action is separate from restoring default distance calibration information and will not change existing calibration

Calibration Guidelines and Errors

Some important things to note about calibration:
• Once a calibration is started, the user should start walking/running (depending on which calibration method
was chosen) immediately. The ActiTrainer has a short inherent delay time built in which should give the
user time to place the unit on their waist or arm prior to collecting calibration data.
• The user must keep a consistent pace. Varying the pace (steps-per-minute) more than 12% during
calibration will result in a pace error which will display in the lower part of the Workout screen (see below).
• The user's pace for a walk cannot exceed 150 steps-per-minute throughout the calibration. Also, the
user's pace for a run cannot drop below 150 steps-per-minute throughout the calibration. Failing to
meet this requirement will result in a speed error which will display in the lower part of the Workout screen
(see below).
*IMPORTANT*
information currently on the device.
22