Table of Contents
Advertisement
10. REMOVE INLET NO. 2 AIR CLEANER
(1) Remove the 2 bolts.
(2) Remove the inlet No. 2 air cleaner from the
inlet No. 1 air cleaner.
11. REMOVE NO. 3 INVERTER BRACKET
(1) Remove the bolt, nut and No. 3 inverter
bracket.
12. REMOVE INVERTER TERMINAL COVER
Caution:
Wear insulated gloves.
(1) Remove the 11 bolts and inverter terminal
cover from the inverter with converter
assembly.
Notice:
・ Make sure to pull the inverter terminal
cover straight up, as a connector is connected to the bottom of the inverter
terminal cover.
・ Do not touch the inverter terminal cover waterproofing rubber.
・ Do not allow any foreign matter or water to enter the inverter with converter
assembly.
13. CHECK TERMINAL VOLTAGE
Caution:
Wear insulated gloves.
Notice:
Do not allow any foreign matter or water to
enter the inverter with converter assembly.
(1) Using a voltmeter, measure the voltage
between the terminals of the 2 phase
connectors.
Standard Voltage: 0 V
22
Advertisement
Table of Contents
