Service Procedures For Gigaset 4010/ 15 Classic/ Comfort Base Station - Siemens Gigaset 4010/ 15 Service Manual

3.3 Service procedures for Gigaset 4010/ 15 Classic/ Comfort base station

Note: For parameters X, Y, option see table below.
Press: "menu-key", 8, 9, X, 76200 (only if X=3 or 4), Y, select option, o.k.
A pos. acknowledge (rising sequence of notes) indicates that the procedure has been
accepted.
Feature
Pause after signal-key
Automatic attenuation correction
(dependant on country)
Time for end of call identification
(to distinguish between 2 ringing pulses of
one call with long pauses between pulses
and 2 separate calls)
Hook-flash-prevention (cradle switch
identification) (short press on cradle switch-
key is extended by SW to prevent that it is
interpreted as a press on the flash-key)
Pause after line seizure
System PIN reset
Programming data on an address
Read out SW-version
Range of ringing frequency recognition
Dial pulsing: pulse pause ratio
CLIP activation
Off-hook CLIP activation
Approval test
Confidential
Version 2.1
Information and
X 76200 Y
1 - 2 1 = 800 ms
1 - 3 0 = off
1 - 4 0 =
1 - 5 0 = 800 ms
1 - 6 1 =
3 76200 -
4 76200 1 Specific code needed
4 76200 2 Example: 01002_.....
4 76200 3 0 = 23- 54 Hz
4 76200 4 0 = 1.5 : 1
4 76200 5 Select 0 (on) or 1 (off)
4 76200 6 Select 0 (on) or 1 (off)
6 76200 6
6
Communication Products
Option
2 = 1600 ms
3 = 3200 ms
1 = on
4 sec.
1 = 5.5 sec.
2 = 7 sec.
3 = 11 sec.
1 = 2000 ms
1 sec.
2 = 3 sec.
3 = 7 sec.
4 = 2.5 sec.
-
01 = SW-variant
002 = SW-version
1 = 20- 60 Hz
2 = 15-75 Hz
1 = 2 : 1
-
ICM D CC ST
J. Junggebauer
05/01