Titan TTB236MSW Safety And Operating Manual page 22

2
Fig 26
TITAN 210MM SLIDING COMPOUND MITRE SAW
Carefully remove the laser housings plastic window
by pushing the two attachment lugs from the rear.
This will enable access to the laser module.
(See fig. 26)
B. Adjusting the Angle of the Laser Guide
1) Loosen the single screw on the RH side
of the laser housing ¼ a turn (see fig. 25)
2) Turn the laser element in the
desired direction to adjust the laser angle.
3) Retighten the adjustment screw.
C. Aligning the Laser Beam
1) Loosen the right hand screw ¼ of a turn.
2) Use the two adjusting screws on the LH side of
the laser housing. (see fig. 24)
3) Adjust both screws until laser alignment is
achieved.
4) Retighten right hand screw.
NOTE: Use only the correct sized hex key when
adjusting these screws. Turn one screw at a time
and only ¼ turn in either direction before checking
laser alignment. Maintain as far as possible the
original factory pressure setting that these screws
exert on the laser module.
TTB236MSW