Chapter 3 Troubleshooting; Led Blinking Pattern; Error Types - Epson TM-P60 Technical Reference Manual

Chapter 3
Troubleshooting
This section describes general troubleshooting.

3.1 LED Blinking Pattern

3.1.1 Error Types

The printer stops all printer operations, goes offline, and the ERROR LED blinks when an error
is detected.
ERROR
Printer temperature
error (*1)
Autocutter error
Circuit error
Memory error
Voltage error
Software error
The radio unit error
Note:
The ERROR LED is on when the printer is offline (paper out, power-on initialization, roll paper cover
open, power-off operation, or the remaining battery charge is not enough for printer operation when the
battery is used to supply the power.)
(* 1) Print temperature error is not an abnormality.
When you see an error described as "Impossible to recover" in the recovery column, turn off the printer as
soon as possible and consult your dealer.
When the printer beeps, see also "Beeping Types" (page 3-2).
Rev. D
Description
The internal temperature
of the printer is extremely
high
The autocutter does not
work correctly
The circuit board doesn't
work
The printer does not work
correctly in R/W checking.
The power supply voltage
is extremely high or low
The firmware does not
work correctly.
The IEEE802.11b radio
interface unit doesn't
work.
TM-P60 Technical Reference Guide
ERROR LED Blinking Pattern
320 ms
Recovery
Recovers automatically
when the printer cools
Recovers by error
recovery command.
(See "Paper Jam"
(page 3-2))
Impossible to recover
Impossible to recover
Impossible to recover
Impossible to recover.
Impossible to recover
Troubleshooting 3-1