5 WHEELCHAIR OPERATION
5.9
Removing/Installing or Tilting the Seat Assembly
Removing/Installing the Seat Assembly - Wheelchairs with Latch Bars Only
WARNING
DO NOT engage or disengage motor locks until the power is in the OFF position.
After ANY adjustments, repair or service and before use, make sure all attaching hardware is tightened securely -
otherwise injury or damage may result.
For this procedure, refer to FIGURE 15.
Removing
1.
Disconnect the joystick cable at rear of seat. Refer to
Disconnecting/Connecting the Joysticks on page 104.
The latch bar will be located behind the front seat
posts on wheelchairs with adjustable ASBA seats
and in front of the front seat posts on wheelchairs
with van seats.
2.
Push down on the latch bar underneath front of seat.
3.
Rotate seat assembly backward.
4.
Slide the seat assembly forward to disengage seat from pivot
brackets located in the rear.
Invacare® TDX® SC, Invacare TDX Spree
Latch Bar
TDX SC with
Transport Brackets
(TRBKTS) shown.
FIGURE 15
Removing/Installing the Seat Assembly - Wheelchairs
62
with Latch Bars Only
Part No 1149267
Rear Pivot
Brackets
Seat Clevis
Pins