Carrier Infinity SYSTXCCITW01 Installation Instructions Manual page 68

(BLUE port) of the TP- - LINKr Wireless Access Point (supplied with the Infinity
Touch Control Wi- - Fi Bundle) to an open LAN port on the homeowner's existing
router using the provided Ethernet cable.
If there are no open LAN ports available on the homeowner's existing router, the
home router's LAN ports may be expanded by use of an Ethernet Network Switch,
available from a local electronics store. Consult the information supplied with the
network switch for instructions on applying and using the network switch.
The LAN ports on the back of the TP- - LINK Wireless Access Point should not be
used for other devices. The TP- - LINK Wireless Access Point should only be used
for connection of the Infinity Touch Control and is not intended to be used, wired or
wirelessly, with any other devices.
Once the Ethernet cable is connected, install the power supply to the Wireless
Access Point, plug the power supply into a household receptacle, and press the
power button on the back of the Wireless Access Point. The power light on the front
of the Wireless Access Point should light and after a few minutes three other
indicator lights will begin to blink (LAN Activity, Wi- - Fi Activity and WAN/Internet
Activity).
Verify the signal strength of the wireless access point radio signal at the desired
location of the Infinity Touch Control with a wireless laptop computer. Use the Scan
for Wireless Networks utility and verify that the signal for "MyHVACxxxxxx" is
"Strong" or better. If not, reposition the wireless access point to provide a strong
signal at the wall control location.
7.2. Connect the Infinity Touch Control to the Wireless Access
Point
Touch the WIRELESS icon from the second page of the Infinity Touch Control
MENU screen. First, enable the Wi- - Fi connection by touching the ENABLE
button.
60