Default = On
d
6.3.1.6.
Smart Recovery Enable
Applies to programmable operation only. Will start recovery 90 minutes prior to
schedule change in both heating and cooling mode. After the selection is made,
touch SAVE.
Smart Recovery: On or Off
S
Default = On
d
6.3.1.7.
Temperature Units Display
This option allows the installer to choose between Fahrenheit and Celsius display.
After the selection is made, touch SAVE.
Display Option: Selectable between _F and _C
S
Default = _F
d
6.3.2.
Fan Coil
First touch SETUP, then touch FAN COIL to set up the parameters for the fan coil
unit.
27
A12188