Unpacking - Procom ML170EPC Owner's Operation And Installation Manual

Burners
Lower Front Panel
LOCAL CODES
Install and use heater with care. Follow all local
codes. In the absence of local codes, use the
latest edition of National Fuel Gas code ANSI
Z223.1, also known as NFPA 54*.
*Available from :
American National Standards Institute, Inc.
National Fire Protection Association, Inc.
1 Batterymarch Park
Quincy, MA 02269 -9101
WATER VAPOR: A BY-PRODUCT OF VENT-FREE ROOM
Water vapor is a by-product of gas combustion. An vent-
free room heater produces approximately one (1) ounce
(30ml) of water for every 1,000 BTU's (.3KW 's) of gas
input per hour.
Vent-free room heaters are intended for supplemental heat
(a room) rather than a primary heat source (an entire house).
In most supplemental heat application, the water vapor does
not create a problem. In most applications, the water vapor
enhances the low humidity atmosphere experience during
cold weather.
The following steps will help insure that water vapor does
not become a problem.
1. Be sure the heater is sized properly for the
PRODUCT FEATURES
Touch Pad
ON/OFF Switch
Safety Pilot
Figure1-Vent-Free Heater
CONTINUED
1430 Broadway
New York, NY 10018
Cabinet Top
Grill Guard
Ignitor
System
Control Knob
Control System
State of Massachusetts : The installation must be
made by a licensed plumber or gas fitter in the
Commonwealth of Massachusetts.
Sellers of unvented propane or natural gas-fired
supplemental room heaters shall provide to each
purchaser a copy of 527 CMR30 upon sale of the
unit.
In the State of Massachusetts, unvented propane
and natural gas-fired space heaters shall be
prohibited in bedrooms and bathrooms.

UNPACKING

1. Remove heater from carton.
2. Remove all protective packaging applied to
heater for shipment.
3. Check heater for any shipping damage. If heater
is damaged, promptly inform dealer where you
bought heater.
application, including ample combustion and ventilation air.
2. If high humidity is experienced, a dehumidifier may be
used to help lower the water vapor content of the air.
3. Do not use a vent-free room heater as the primary heat
source.
IMPORTANT: Vent-free heaters add moisture to
the air. Although this is beneficial, installing heater
in rooms without enough ventilation air
cause mildew to form from too much moisture.
See Fresh Air for Combustion and Ventilation, pages
5 and 6.
4
for Manual Override Control
Door
for Manual Override
HEATERS
may