Procom ML170EPC Owner's Operation And Installation Manual page 12

OPERATING YOUR HEATER
continued
SETTING TIMER
Auto on
: With burner off, press
TIMER button. Then press
change to the scheduled time, then
press the TIMER button again, the
TIMER starts timing and the TIMER
will flash. Burner will automatically
come on at the set time.
AUTO OFF: With burner operating,
press TIMER button. Then press
to change to the scheduled time,
then press the TIMER button again,
the TIMER starts timing and the
TIMER will flash. Burner will auto-
matically shut off at the desired time.
LOCKING TOUCH-PAD
(child proof)
A. Key-press locking: Press LOCK
button on the operating panel,
a symbol will appear on the
LCD.
B. Key-press unlocking: Press
then press LOCK button to unlock.
OPERATING BLOWER
Press BLOWER button, for desired
burner operation.
AUTO: Blower will come on
several minutes after burner
comes on and will go off several
minutes after burner goes off.
MAN: Blower operates
OFF: Blower is off.
TO TURN OFF GAS
TO HEATER
1.Press the IGN/OFF button on the
touch pad.
2.Set the ON/OFF switch to OFF
or to
position on top panel.
Wait one minute to light
NOTE:
again after shutting off heater.
MANUAL OPERATING
INSTRUCTIONS
We provide the manual control sys-
tem just in case of power shortage.
or
Install battery for Manual Ignitor:
1. Unscrew the ignitor cap.
2. Insert a AAA type battery with its
anode ("+") pointing out.
3. Screw the ignitor back cap.
Note: We recommend that the battery
be taken out of the ignitor when the
power supply gets right.
IF NO ELECTRIC POWER IS
AVAILABLE, HEATER CAN BE OPER-
ATED MANUALLY
1. STOP! Read the safety information
on page11 before lighting.
,
Control Knob
2. Check that gas supply to the
heater is on.
3. Remove round access door of
right side panel. Push in control
knob slightly and turn clockwise
to the OFF position.
4. W ait five (5) minutes to clear any
5. Push in gas control knob slightly and
6. With control knob pressed, push
7. Keep control knob depressed for
Ignitor Button
8. Rotate counterclockwise
12
If the manual control knob points to
ELECTRIC position, press in the
control knob and turn counter clock-
wise to OFF position.
gas. Then smell for gas, including
near the floor. If you smell gas,
STOP! Follow "B" in the safety in-
formation on page11. If you do not
smell gas, go to the next step.
turn counterclockwise
I G N an d d e p r es s f o r f ive ( 5 )
seconds. NOTE:The first time the
heater is operated after connecting
the gas supply, the control knob
should be depressed for about thirty
(30) seconds. This will allow air to
exit the gas system.
and release ignitor button. This
will light the pilot. If needed, keep
pressing ignitor button until pilot
lights.
ten (10) seconds after lighting
pilot. If pilot goes out,repeat steps
5,6 and 7.
ON position to light burner. Do not
operate between locked positions.
to PILOT/
to