Other Problems - ECOVACS Deebot D54 User Manual

There is much noise when the robot
5
works.

13.Other Problems

1. How long can robot last working under
full battery?
Answer: It differs from the ground situation,
It takes around 45 minutes for even floor
such as wooden floor and ceramic tile, and
20 minutes for short-haired carpet.
2. Is it allowed for the robot to work
independently without taking care of?
Answer: Yes. However, you should keep
person in the room informed about robot
operating to avoid tripping.
3. What kind of equipment inside the robot
is used for dealing with failure?
Answer: It is equipped with photosensitive
components which can detect the stair over
the height of 8 centimeters; for fear that it
would fall over.
4 . Is robot able to clean the bottom of the
furniture?
Answer: It is flat design, during normal
cleaning, it can go into table and bed corner
whose height is over 10 centimeters, such as
bed, wardrobe, sofa and tea table.
5 . Why does robot fail to work under set
mode?
Answer: Because when there is low
battery, it will do back to charging mode
automatically.
6 . What's the cleaning coverage once it is
charged full?(under automatic cleaning
21
Turn off the power supply, and then take out of
dust box. After removing the garbage,
overturn the robot.
1. Check whether the suction of main brush is
blocked.
2. Examine and clean the main brush.
3. Examine and clean the side brush.
If the failure is still there after operating
according to the above procedure, Please
contact out after-sales service.
mode)
Answer: Under normal circumstance, it is
around 90-120 sq, but it differs from the
ground situation.
7 . Why does robot stop working once it
meets obstacle?
Answer: Under normal circumstance,
robot will return or seek other route when
it meets obstacle. However, if it
controlled by remote control, it is not
able to change route in case of obstacle.
8. Why there is garbage leaking from the
machine while robot operating?
Answer: a. Please check whether there is
too much garbage in dust box(if there is
too much dust on the floor, robot is not
able to alarm after working for some time
even though there is too much garbage in
dust box.). That's why you need to clean
dust box. b. See whether main brush is not
cleaned for long time, as it is tangled with
much hair and dust.
9. Why does robot fail to start cleaning on
appointment time?
Answer: a.Confirm whether there is much
remaining battery. Appointment timing is not
applicable when robot is returning to charge
after operating cleaning. b. Check if robot is
under standby status.