Management-Module Error Messages - IBM BladeCenter T Type 8730 Hardware Maintenance Manual

Note: See Chapter 7, "Parts listing, BladeCenter T Type 8720 and 8730," on page 107 to determine which
components should be replaced by a field service technician.
Message
LAN: Ethernet [x] interface now longer
active

Management-module error messages

Note: See Chapter 7, "Parts listing, BladeCenter T Type 8720 and 8730," on page 107 to determine which
components should be replaced by a field service technician.
Message
Application posted alert to ASM
System log 75% full
System log full
Management module network
initialization complete
Remote login successful. Login ID
ASM reset was caused by restoring
default values
ASM reset was initiated by the user
Pushbutton reset activated: Ethernet
configuration reset to default values and
MM ASM reset due to watchdog timeout
ASM reset due to XXXXX, instruction
fault: XXXXXXXX YYYYYYYY ZZZZZZ
ASM reset reason unknown
Possible ASM reset occurred reason
unknown
Remote access attempt failed. Invalid
userid or password received. User is
XXX from CMD mode client at
IP@=XXX.XXX.XXX.XXX
Remote access attempt failed. Invalid
userid or password received. User is
XXX from WEB browser
IP@=XXX.XXX.XXX.XXX
DHCP [X] failure, no IP @ assigned (retry
X), rc=X
LAN: Command mode tamper triggered.
Possible break in attempt.
LAN: WEB server tamper delay
triggered. Possible break in attempt.
System log cleared.
Action
Information only. Take action as required.
Action
The alert button on the Web interface was tested. Information only.
Take action as required.
Information only. Take action as required.
Information only. Take action as required.
Information only. Take action as required.
Information only. Take action as required.
The management-module assembly was reset after restoring the
default settings. Information only. Take action as required.
Information only. Take action as required.
1. Reseat the management module.
2. Reflash the management-module firmware.
3. Replace the management module.
1. Reseat the management module.
2. Reflash the management-module firmware.
3. Replace the management module.
Information only.
Information only.
Failed attempt to log into the management module.
Failed attempt to log into the management module.
Failed to get IP address by DHCP server. Check the DHCP server
connection and settings.
Unsuccessful attempt to access the management module in
command mode. Information only. Take action as required.
Unsuccessful attempt to access the management module in
command mode. Information only. Take action as required.
Information only. Take action as required.
Chapter 6. Symptom-to-FRU index
103