Installing A Power Module - IBM BladeCenter T Type 8730 Hardware Maintenance Manual

2. Grip the power-module handle with one hand and slowly pull the power module
3. Place the power module in a safe location.
4. Within 1 minute, install either another power module or a filler module into the

Installing a power module

Complete the following steps to install a power module at the front of the
BladeCenter T unit. The procedure is the same for both ac-power and dc-power
modules.
Attention:
you replace a removed power-module filler panel with a power module within 1
minute.
1. Note the orientation of the power module or filler you are removing; then,
2. Press the blue release button on the front of the new power module to release
3. Grip the power-module handle with one hand and support the bottom of the
4. Orient the new power module to the selected power-module bay; then, slide the
5. Push the power-module handle in until it locks into the latch next to the blue
6. Make sure the LEDs on the power module indicate that it is operating correctly.
7. If you have other modules to install at the front of the unit, do so now.
48
BladeCenter T Type 8720 and 8730: Hardware Maintenance Manual and Troubleshooting Guide
out of the bay. Use your other hand to support the bottom of the power module
as you pull the power module out from the bay.
Attention: Do not carry the power module by only the power-module handle.
You must support the weight of the power module.
selected power-module bay.
To help ensure proper cooling and system reliability, make sure that
remove the filler or power module from the selected power-module bay and set
it aside.
the power-module handle; then, move the power-module handle outward until it
is in the open position (90° from the closed position).
power module with the other hand.
Attention: Do not carry the power module by only the power-module handle.
You must support the weight of the power module.
power module into the bay until it stops.
release button.
Make sure that:
v The input power LED is lit.
v The output power LED is lit.
v The error LED is not lit.
Otherwise reinstall the bezel assembly at the front of the BladeCenter T unit.