IBM BladeCenter T Type 8730 Hardware Maintenance Manual page 96

19. Holding the backplane at the top near the guide pins, pull the backplane out
20. Remove the backplane insulator.
21. Remove the old mechanical chassis, and set it aside.
22. Remove the new mechanical chassis from its packaging, and set it into
23. Install the backplane insulator into the new chassis.
24. Install the backplane on the chassis; then, insert and tighten the six
25. Install the rear chassis stiffner bracket (see page 78).
26. Install the left and right docking board/blower housing assemblies (see page
27. Install the two upper flex circuit assemblies (see page 71).
28. Install the two lower flex circuit assemblies (see page 72).
29. For Type 8720, reinstall the rear dc panel (see "DC Rear Panel" on page 70).
30. Install the blowers at the rear of the unit (see "Installing a blower module" on
31. Install the KVM module at the rear of the unit (see "Installing the KVM module"
32. Install the LAN module at the rear of the unit (see "Installing the LAN module"
33. Install the I/O switches at the rear of the unit.
34. Install the media tray at the front of the unit (see "Installing the media tray" on
86
BladeCenter T Type 8720 and 8730: Hardware Maintenance Manual and Troubleshooting Guide
and off of the guide pins.
position to reassemble all the parts.
non-captive screws that mount the backplane to the chassis.
Note: Tighten the screws to 8 inch-pounds.
76).
For Type 8730, reinstall the rear ac panel (see "AC rear panel" on page 69).
page 55).
on page 57).
on page 59).
page 50).
Mechanical chassis
U P