Connecting Equipment and Power to the UPS
3000XLV Model Rear Panel
1
2
3
INDEX
ITEM
1 & 2
Serial Port & USB Port
3
Voltage Selection Switch
4
Site Wiring Fault LED
5
Network Port
6
Network Reset Button
7
Extend Run Battery Pack Con-
nector
8
Input Cord
9, 10 &
Outlet Banks 1, 2 & 3
11
12, 13 &
Circuit Breakers for Outlet Banks
14
1, 2 & 3
3000XHV Model Rear Panel
INDEX*
ITEM
1
Input Circuit Breaker
2
Input Connector
3, 4 & 5
Outlet Banks 1, 2 & 3
*Exceptions from the 3000XLV are noted here.
6
7
5
4
DESCRIPTION
Power management software and interface kits can be used with the
UPS. Use only interface kits supplied or approved by IBM.
Use the supplied serial cable to connect to the serial port. DO
NOT use a standard serial interface cable since it is incompatible
with the UPS connector.
Serial and USB ports cannot be used simultaneously.
See Setting the Nominal Voltage.
See Troubleshooting.
See Quick Installation Guide.
Reset the Embedded Network Module.
See Extend Run Battery Pack Operation and Setup Guide.
See Startup.
Separate outlet banks are controlled by the Embedded Network
Module. See Embedded Network Module CD.
See Troubleshooting.
DESCRIPTION
See Troubleshooting.
See Startup.
Separate outlet banks are controlled by the Embedded Network
Module. See Embedded Network Module CD.
8
11
10
9
8
13
12
1
2
3
4
14
5