Abort Handling - IBM Ultrium Internal Tape Drive T200 Reference Manual

Attention Check Condition from each initiator gets a Check Condition status, with
Unit Attention sense data for the reset. However, other commands may not be
processed until the internal state of the drive has been reset. Any commands that
allow Disconnects and cannot be processed are accepted and queued until the
drive is ready to process them. Those commands that do not allow Disconnects
receive Busy status response.

Abort Handling

If a command is aborted on a drive with a Fibre Channel interface, see Table 110
for abort processing.
If a command is aborted on a drive with a SCSI interface, one of the following
conditions will occur:
v If an abort condition is detected before a command phase completes, the bus is
v If an abort condition is detected during status phase, the bus is set to bus free.
v If an abort condition is detected between the end of the command phase and the
94
Ultrium Internal Tape Drive and 3580 Ultrium Tape Drive: SCSI Reference
set to Bus Free and the command is not executed.
start of the status phase, then the bus is set to Bus Free and the processing in
Table 110 on page 94 is carried out.
Table 110. Abort Condition Handling
Command
ERASE
INQUIRY
LOAD/UNLOAD
LOCATE
LOG SELECT
LOG SENSE
MODE SELECT
MODE SENSE
PERSISTENT RESERVE IN
PERSISTENT RESERVE
OUT
PREVENT/ALLOW MEDIUM
REMOVAL
READ
READ ATTRIBUTE
READ BLOCK LIMITS
READ BUFFER
READ POSITION
Abort Processing
Long erase is aborted as quickly as possible without
corrupting tape format. Short erase completes.
None.
Load completes and logically positions tape at BOM. Unload
is aborted, leaving logical position at BOM unless operation
is past the 'point of no return', in which case the tape is
ejected.
The logical position is set back to that at the start of the
operation unless the operation is past its 'point of no return',
in which case the operation completes.
If data transfer is completed, command is completed;
otherwise, no action is taken.
None.
If data transfer is completed, command is completed;
otherwise, no action is taken.
None.
None.
If data transfer is completed, the command is completed;
otherwise, no action is taken.
The command completes.
The current position is set to the first record boundary at or
after the start of the current data burst.
None.
None.
None.
None.