Accessing The Dip Switches; Setting The Camera Id - Lorex LZC7091 Instruction Manual

Super+ resolution 10x ptz speed-dome camera

Hide thumbs Also See for LZC7091:

Table of Contents

Changing Protocol Information

5.1 ACCESSING THE DIP SWITCHES

To access the DIP switches, you must remove the camera from the case.

To do this, you must remove the camera from the case. Rotate the dome

cover counterclockwise to remove. Remove the base attachment screws

(3x) and remove the camera base. See illustration below.

The camera ID is how the DVR identifies PTZ cameras.

Camera ID is set using the larger DIP switch panel with 8 switches. Each

switch represents a binary digit (i.e. switch #1=1, #2=2, #3=4, etc.).

Camera ID can be anything between 1-255. See the address example

table on the next page.

Dome

cover

Removing the camera from the case

Camera ID DIP Switches

Base attachment

screws

Camera

Camera base

Table of Contents