3.7.7.1
Active
Set up Active state. Low/High will be different depend on machine..
3.7.7.2
Function
The following list contains a brief description of each function.
3.7.7.2.1
Direction : IN
UNUSED:
ALARM RESET IN:
RECORD START IN:
RECORD ON/OFF:
3.7.7.2.2
Direction : OUT
ALRAM OUT:
ERROR OUT:
RECORD START OUT:
DISK FULL:
RECORD STATUS:
3.7.8 Factory Default
All of set-up date of system comes back to Factory default.
Confirmation box on picture setting default will appear after entering default. User can
restore the factory default setting after entering 'YES' key button.
Please refer to paragraph 5.3 for factory default.
4 & 8 & 16 Channel DVR Operation manual Revision 1.0
Do not use the AUX port.
Pause alarm or buzzer when event occurred
Record is on while external signal comes in.
Recording start/stop during user push the button & same as
pushing remote controller or DVR machine
Notice the assigned port when event occurred
Notice the assigned port when system error occurred
(Mark system error)
HDD of DVR is full(100%), send signal to DVR
which is connect with AUX port. During receiving recording
signal through AUX port, it can record it and the mode of DVR
AUX in port is RECORD
If HDD is full, send signal to the AUX port.
Indicate whether it is recording or not
66