Model No; Ptz Id; Reverse Control; Setting - Monacor DMR404 User Manual

It sets PTZ protocol of targeted channel in the Camera Setup. (Please refer to paragraph
3.1.1 for channel selection)
3.1.5.1

Model No

Select the PTZ model or choose "NONE".
3.1.5.2

PTZ ID

Set the PTZ ID: 0 ~ 255
The PTZ ID must match the ID number that has been set by the PTZ Controller. Please
verify the ID on the Controller first before setting the PTZ ID.
3.1.5.3

Reverse Control

Without any further changing of cable connection, user can control PTZ controller by
changing reverse direction of PTZ. Each PAN, TILT, ZOOM, FOCUS will be selectable to
reverse direction and each parameter will be selectable ON /OFF.
3.1.5.4 RS-485 Setting
Choose from the following to set PTZ RS-485 baud rate: 2400, 4800, 9600, 19200, 38400,
57600, 115200 bps.
3.1.5.5

TEST

Users can test the PTZ control after setting the parameters. After clicking the TEST button,
PTZ control will be available and tested by up/down key. Pan/tilt and Zoom/Focus mode will
be controlled after entering OK key button.
PTZ control speed will be controlled by PLAY button for higher speed or by R.PLAY button
for precision control
Users can access prior menu with PTZ key entering after finishing test.
3.1.5.6

Additional PTZ Menus

Users can access additional PTZ menu after pressing Menu button in the PTZ mode.
4 & 8 & 16 Channel DVR Operation manual Revision 1.0
35