Audio; Rs-232; Ptz/Aux/Alarm - Monacor DMR404 User Manual

Digital hard disk recorder 4/8/16 channel, mpeg-4

Table of Contents

1.5.1.3 Audio

Use IN for a Line input and OUT for speaker output.

OUT

Use this connector to connect RS-232 cable to the serial port on your PC to control

the DVR or to perform Quick Installation.

1.5.1.5.3 Alarm Out (NO, COM, NC)

The Alarm output is activated using a relay contact point when an alarm event occurs for the

duration of the alarm event.

Select from Normal Open Relay or Normal Close Relay.

N.O. (Normal Open) is disconnected from COM during normal status and connected to COM

during alarm event. N.C. (Normal Close) is connected from COM during normal status and

disconnected to COM during alarm event.

4 & 8 & 16 Channel DVR Operation manual Revision 1.0

1.5.1.5.1 RS-485+, RS-485-

DVR uses RS-485 protocol to control PTZ Receiver, Speed Dome, and

Auto-focus camera. Be sure to match the polarity.

1.5.1.5.2 AUX 1~5

AUX Port consists of 2 input ports (AUX 1,2) and 3 output ports (AUX 3, 4,

5) and the function of each port is selectable according to user's purpose,

user's access to external DVR, or controllers using the supplied DB-15

connector.

Table of Contents