Table of Contents
Advertisement
115
You should do HDD JUMPER setting before or after HDD & BRACKET. This setting
methods are different according to HDD manufacturer.
Generally you can find some setting information on the top of HDD, you can follows those
instructions.
In case of one HDD installation, set HDD to 'MASTER' or 'SINGLE' .
In case of two HDD, one HDD set to 'MASTER', the other HDD set to 'SLAVE'.
If you finish the installation of HDD& BRACKET, Put those finished HDD into DVR.
You can do it as above drawing. Pay attention to the direction of HDD connector.
Be careful of front panel cable might be stuck in HDD set and DVR.
Volts can be used same ones when you disassembled.
4 & 8 & 16 Channel DVR Operation manual Revision 1.0
Advertisement
Table of Contents
