Lexmark MS410 series User Manual page 119

Troubleshooting
Paper too short [34]
Try one or more of the following:
•
Load the correct size of paper in the tray.
•
From the printer control panel, press
•
Check the tray length and width guides and make sure the paper is loaded properly in the tray.
•
Make sure the correct paper size and type are specified in Print Properties or in the Print dialog.
• Make sure the paper size and type settings are specified in the Paper menu on the printer control panel.
•
Make sure the paper size is correctly set. For example, if the MP Feeder Size is set to Universal, then make sure the
paper is large enough for the data being printed.
• Cancel the print job.
Parallel port disabled [56]
Try one or more of the following:
• From the printer control panel, press
Note: The printer discards any data received through the parallel port.
• From the printer control panel, set Parallel Buffer to Auto.
Printer restart. Check last job.
Press on the printer control panel to clear the message and continue printing.
For more information, visit
Rear USB port disabled [56]
Try one or more of the following:
• From the printer control panel, press
Note: The printer discards any data received through the USB port.
• From the printer control panel, set USB Buffer to Auto.
Reinstall missing or unresponsive cartridge [31.xy]
Try one or more of the following:
•
Check if the toner cartridge is missing. If missing, install the toner cartridge.
For information on installing the cartridge, see the "Replacing supplies" section of the User's Guide.
•
If the toner cartridge is installed, then remove the unresponsive toner cartridge, and then reinstall it.
Note: If the message appears after reinstalling the supply, then the cartridge is defective. Replace the toner
cartridge.
to clear the message and print using a different tray.
to clear the message and continue printing.
http://support.lexmark.com
to clear the message and continue printing.
or contact customer support.
119