Required Mag Context Configuration Information; Required Aaa Context Configuration Information - Cisco ASR 5000 Series Administration Manual

▀ Configuring the System to Perform as a Standalone HSGW
Required Information Description
Security Parameter eAN/ePCF IP address:Specifies the IP address of the eAN/ePCF. The HSGW service allows the
Index Remote creation of a security profile associated with a particular eAN/ePCF.
Address
SPI number:Specifies the SPI (number) which indicates a security context between the eAN/ePCF and
the HSGW.
Encrypted secret:Configures the shared-secret between the HSGW service and the eAN/ePCF. This
command can also be non-encrypted.

Required MAG Context Configuration Information

The following table lists the information that is required to configure the MAG context on an HSGW.
Required Description
Information
MAG context An identification string from 1 to 79 characters (alpha and/or numeric) by which the MAG context is recognized
name by the system.
S2a Interface Configuration (To/from P-GW LMA)
Interface An identification string between 1 and 79 characters (alpha and/or numeric) by which the interface is recognized
name by the system.Multiple names are needed if multiple interfaces will be configured.
IP address IPv6 address assigned to the interface.Multiple addresses and subnets are needed if multiple interfaces will be
and subnet configured.
Physical port The physical port to which the interface will be bound. Ports are identified by the chassis slot number where the
number line card resides followed by the number of the physical connector on the card. For example, port 17/1 identifies
connector number 1 on the card in slot 17.A single physical port can facilitate multiple interfaces.
Gateway IP Used when configuring static IP routes from the management interface(s) to a specific network.
address
MAG Service Configuration
MAG Service An identification string from 1 to 63 characters (alpha and/or numeric) by which the MAG service is recognized
Name by the system.

Required AAA Context Configuration Information

The following table lists the information that is required to configure the AAA context on an HSGW.
Required Description
Information
Gxa Interface Configuration (to PCRF)
Interface name An identification string between 1 and 79 characters (alpha and/or numeric) by which the interface is
recognized by the system.Multiple names are needed if multiple interfaces will be configured.
▄ Cisco ASR 5000 Series HRPD Serving Gateway Administration Guide
HSGW Configuration
OL-22984-01