Cisco ASR 5000 Series Administration Manual page 63

HSGW Configuration
Required Description
Information
IP address and IPv6 addresses assigned to the interface.Multiple addresses and subnets are needed if multiple interfaces will
subnet be configured.
Physical port The physical port to which the interface will be bound. Ports are identified by the chassis slot number where
number the line card resides followed by the number of the physical connector on the card. For example, port 17/1
identifies connector number 1 on the card in slot 17.A single physical port can facilitate multiple interfaces.
Gateway IP Used when configuring static IP routes from the management interface(s) to a specific network.
address
Gxa Diameter Endpoint Configuration
End point name An identification string from 1 to 63 characters (alpha and/or numeric) by which the Gxa Diameter endpoint
configuration is recognized by the system.
Origin realm An identification string between 1 through 127 characters.The realm is the Diameter identity. The originator's
name realm is present in all Diameter messages and is typically the company or service name.
Origin host An identification string from 1 to 255 characters (alpha and/or numeric) by which the Gxa origin host is
name recognized by the system.
Origin host The IPv6 address of the Gxa interface.
address
Peer name The Gxa endpoint name described above.
Peer realm name The Gxa origin realm name described above.
Peer address and The IPv6 address and port number of the PCRF.
port number
Route-entry peer The Gxa endpoint name described above.
STa Interface Configuration (to 3GPP AAA server)
Interface name An identification string between 1 and 79 characters (alpha and/or numeric) by which the interface is
recognized by the system.Multiple names are needed if multiple interfaces will be configured.
IP address and IPv4 addresses assigned to the interface.Multiple addresses and subnets are needed if multiple interfaces will
subnet be configured.
Physical port The physical port to which the interface will be bound. Ports are identified by the chassis slot number where
number the line card resides followed by the number of the physical connector on the card. For example, port 17/1
identifies connector number 1 on the card in slot 17.A single physical port can facilitate multiple interfaces.
Gateway IP Used when configuring static IP routes from the management interface(s) to a specific network.
address
STa Diameter Endpoint Configuration
End point name An identification string from 1 to 63 characters (alpha and/or numeric) by which the STa Diameter endpoint
configuration is recognized by the system.
Origin realm An identification string between 1 through 127 characters.The realm is the Diameter identity. The originator's
name realm is present in all Diameter messages and is typically the company or service name.
Origin host An identification string from 1 to 255 characters (alpha and/or numeric) by which the STa origin host is
name recognized by the system.
OL-22984-01
Configuring the System to Perform as a Standalone HSGW ▀
Cisco ASR 5000 Series HRPD Serving Gateway Administration Guide ▄