Required Hsgw Context Configuration Information - Cisco ASR 5000 Series Administration Manual

HSGW Configuration
Required Description
Information
Security The name or names of the security administrator with full rights to the system.
administrator
name
Security Open or encrypted passwords can be used.
administrator
password
Remote access The type of remote access that will be used to access the system such as telnetd, sshd, and/or ftpd.
type(s)

Required HSGW Context Configuration Information

The following table lists the information that is required to configure the HSGW context on an HSGW.
Required Information Description
HSGW context name An identification string from 1 to 79 characters (alpha and/or numeric) by which the HSGW context is
recognized by the system.
Diameter The name of the Diameter dictionary used for authentication.
authentication
dictionary
Diameter endpoint An identification string from 1 to 63 characters (alpha and/or numeric) by which the Diameter endpoint is
name recognized by the system.The Diameter endpoint name identifies the configuration used to communicate
with the 3GPP AAA server in the AAA context.
Accounting policy An identification string from 1 to 63 characters (alpha and/or numeric) by which the accounting policy is
name recognized by the system. The accounting policy is used to set parameters for the Rf (off-line charging)
interface.
A10/A11 Interface Configuration (To/from eAN/ePCF)
Interface name An identification string between 1 and 79 characters (alpha and/or numeric) by which the interface is
recognized by the system.Multiple names are needed if multiple interfaces will be configured.
IP address and subnet IPv4 addresses assigned to the interface.Multiple addresses and subnets are needed if multiple interfaces
will be configured.
Physical port number The physical port to which the interface will be bound. Ports are identified by the chassis slot number
where the line card resides followed by the number of the physical connector on the card. For example,
port 17/1 identifies connector number 1 on the card in slot 17.A single physical port can facilitate
multiple interfaces.
Gateway IP address Used when configuring static IP routes from the management interface(s) to a specific network.
HSGW Service Configuration
HSGW service name An identification string from 1 to 63 characters (alpha and/or numeric) by which the HSGW service is
recognized by the system.Multiple names are needed if multiple HSGW services will be used.
OL-22984-01
Configuring the System to Perform as a Standalone HSGW ▀
Cisco ASR 5000 Series HRPD Serving Gateway Administration Guide ▄