Cisco ASR 5000 Series Administration Manual page 69

Hrpd serving gateway

Hide thumbs Also See for ASR 5000 Series:

Table of Contents

HSGW Configuration

Notes:

The HSGW-to-ePCF (A10/A11) interface must be an IPv4 address.

Set the accounting policy for the Rf (off-line charging) interface. The accounting level types supported by the

HSGW are: PDN, PDN-QCI, QCI, and subscriber. Refer to the Accounting Profile Configuration Mode

Commands chapter in the Command Line Interface Reference for more information on this command.

The

FQDN discovery.

Configuring Static IP Routes

Use the following example to configure static IP routes for data traffic between the HSGW and the eAN/ePCF and/or P-

GW:

Notes:

Static IP routing is not required for configurations using dynamic routing protocols.

Creating an HSGW Service

Use the following configuration example to create the HSGW service:

OL-22984-01

, and

Cisco ASR 5000 Series HRPD Serving Gateway Administration Guide ▄

Configuring the System to Perform as a Standalone HSGW ▀

commands are used during P-GW

Table of Contents