Table of Contents
Advertisement
Problem/Symptom
Register failed
LCD Messages
Local Menu Configuration Messages
The following messages may appear in the LCD screen when accessing the phone's menu:
Message
conf timeout!
conf exception!
Saved!
Write Fail!
Wrong Ext Number!
Wrong input!
wrong password!
IP Phone Running Messages
The following messages may appear in the LCD screen while you use the phone:
Message
AW UNREACHABLE!
Basic-Idle
DHCP FAIL!
DUPLICATE IP!
•
Check that the extension number and extension password are set up
properly and that the system administrator enabled the IP extension.
•
Ask the System administrator to confirm that the IP Phone Service is
started in MaxCS.
•
If an analog phone or other IP phone is already logged on to the same
extension, rebooting the IP 805 will not register the phone
successfully. You must press #27 on the IP phone to actively log on
to AltiServ. After the extension is logged on and activated, calls will
be redirected to this phone.
After 2 minutes inside the configuration menu, if no action is taken, the LCD will
show this message and then close the menu.
During configuration, an unknown exception occurred.
The changed configuration was saved.
An error occurred when saving the changed options into flash ROM.
The extension number that you entered is invalid.
You entered an invalid value or string during configuration.
You entered an invalid password from the phone menu.
Failed to connect to the AltiGen phone server. You are trying to register the IP
phone with an invalid IP address, or the AltiGen Phone Server's IP address is
invalid.
The network connection has been lost in offhook or connect state.
Refer to "MaxCS is unreachable" section of "Troubleshooting" on page 25.
The phone is operating in Basic mode.
Press #27 again to reactivate.
Check the IP Phone Service.
Verify that the extension is configured for dynamic.
Although DHCP was enabled, the phone was not able to receive the IP address
from the DHCP server.
Another device configured with the same IP address has been detected. The phone
cannot function correctly until this is corrected.
Solution
Explanation
Explanation
IP 805 User Manual
Appendix A
27
Hide quick links:
Advertisement
Table of Contents
